npt 1/2 home brew bulkhead ball valve stainless steel 304 for Homebrew beer Kettle tap equipment kit, weldless water tank spigot (1 pc)

Very well made and strong.If ever I need an other 1 I will order from this company.A solid 5 stars.

Great product perfect fit

This was easy to install - I purchased a Harbor Freight step bit to bore the hole 13/16". You MUST use a washer on both sides to properly squish the silicone gaskets provided. I added a small thin nut on the outside threads of the nipple to jam up against the back of the ball valve to keep it oriented correctly. I did not like the restricted flow with the interior gaskets installed so I did not use those (last photo of white gaskets). They install inside each end of the ball valve and drastically reduce flow.

The price is very good for the quality. I ships with a roll of sealant tape and extra rubber washers.

Prior to this purchase I was at first not sure due to some of the reviews. Then after looking at some of the pictures and re-reading the reviews in question that had pictures, all I have to say is those folks cannot follow simple instructions. YES you have to use the Teflon tape and I recommend wrapping at least 4/5 times. In addition the silicone washer goes on the INSIDE, not the outside. Use two adjustable wrenches when building too, don’t worry about over tightening, yet do not put HeMan strength into it. I did not put Teflon tape on the inside, since that’s why there is the silicone washer, also for sanitary reasons to clean. Lastly I am very satisfied with this purchase, for it saved me a ton of cash not having to purchase a pre made wort chiller and separator that goes for up to 250 dollars. Also first time filling with water it DID NOT LEAK.

I used this to convert a home depot water cooler to a mash tun. I did need to buy a female 1/2 npt adapter for the inside barb fitting. I didn't use the nut as is took up too much space on the nipple, but the female adapter was able to hold the washer in place to seal the o-ring. Tested at 190 degrees, no leaks. Only 1/3 of a quart of dead space at the bottom with the false bottom I used. Definitely recommend.

Worked great. I didn’t love the rubber washers for installing on an igloo cooler because they’re not thick enough and leaked. I put other larger washers on the the leak stopped. The valve itself is great quality and has performed well for several batches of beer. I think this will last for years.

The media could not be loaded. Can’t get to not leak… Even with seal tape water following threads to outside and dripping…