BIGTREETECH TFT35 V3.0 Graphic Smart Display Controller Board for 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes

Functions perfectly. I needed the 12684 LCD feature to able to properly use the Filament Change script in Cura, but I wanted the Touchscreen feature for everything else. I love it.

Funziona alla grande, è un pò delicato, ma funziona molto bene

This touchscreen arrived promptly and packaged well with plenty of padding.Unfortunately, it comes with no instructions or anything, so you have to rely on the internet for these!Easily plugs in to the SKR V1.3 board with the supplied cables.Upon power up, I had the message saying "LCD12864 Simulator" showing, and nothing obvious as to how to get out of this. I found that by holding down the big wheel for 3 seconds, you can then put it into touch screen mode which will then show the icons and work as it should.Updating the firmware was easy...you will need an SD card to copy over the .bin file, then just reset the screen using the reset button. It will then automatically update.You can also customise the logos and icons...a similar process to updating the firmware but make sure your images are the correct size.I've yet to install this on my printer ,but this should be a breeze to do as its all pretty much setup, I just need to put it into place. A worthy buy!

Facile da usare e da collegare

Installed with BTT skr V2 & ESP(for wifi) plus this screen and 3DTouch, also 5 x TMC2209 driversInstalled on Artillery Sidewinder X1 with Marlin 2.0.9 firmware, modified :)Very good. Can't fault it (yet - still early days)Nice upgrade, and use either touch screen or marlin mode. Each have their own merits.